In this section, three Tenant segments are created and connected to the Tier-0 gateway:
- App-Segment
- DB-Segment
- Web-Segment
To create the Tenant segments, perform the following steps:
- Connect to the NSX Manager UI and go to Networking > Segments.
- On the Segments tab, click ADD SEGMENT.
- On the segment configuration page, the following items are configured:
- Segment Name – App-Segment.
- Connectivity – Select GW-Router | Tier1 from the drop-down menu.
- Transport Zone – Select Edge-Overlay-TZ from the drop-down menu.
- Subnets – For this deployment, the gateway is set to 10.10.10.254/24.
- Leave the remaining settings at defaults and click SAVE.
- When asked to continue configuring the segment, click No.
- Repeat steps 2 through 4 above to create the Web-segment segment using the same settings.
- From the Subnets section, change the gateway to 20.20.20.254/24.
- Repeat steps 2 through 4 above to create the DB-Segment segment using the same settings.
- From the Subnets section, change the gateway to 30.30.30.254/24.
When complete, the SEGMENTS page displays as shown below, with the tenant segments outlined in red.