Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Deployment Guide—Dell EMC PowerFlex with Dell EMC PowerEdge MX7000 Chassis
Introduction MX7000 Build Overview Physical Deployment Configuring the switches Configuring the PowerEdge MX7000 Chassis Configuring the PowerFlex R640 Management Node
Introduction
Installing and configuring VMware ESXi
Installing vCSA
Adding ESXi host to the VMware vCenter
Creating the Front-End DVSwitch
Creating the FE_dvSwitch distributed port groups
Creating the Back-End DVSwitch
Creating the BE_dvswitch distributed port groups
Create LAG on the new DVSwitches
Modifying Failover Order for BE_dvSwitch
Migrating Interfaces to BE_dvswitch
Modifying the failover order for the FE_dvSwitch
Adding first uplink to FE_dvswitch
Migrating vCenter to FE_dvswitch
Migrating the second uplink and VMkernel port
Creating the Out of Band dvswitch
Creating the oob_dvswitch distributed port group
Adding a host to oob_dvswitch
Deleting the Standard Switch (vSwitch0)
Deploying a Jump Server Configuring the MX740c ESXi Compute Sleds Deploying PowerFlex Two-Layer Deploy SDC on ESXi Servers Validated Components Technical Resources

Adding first uplink to FE_dvswitch

Home > Storage > PowerFlex > Guides > Deployment Guide—Dell EMC PowerFlex with Dell EMC PowerEdge MX7000 Chassis > Adding first uplink to FE_dvswitch

Adding first uplink to FE_dvswitch

    1. Go to Networking > FE_dvswitch.
    2. Click Configure and in Settings, click LACP.
    3. Click Migrating network traffic to LAGs.
    4. Click Add and Manage Hosts.
    5. Click Add Hosts and click Next.
    6. Click New Host, click the host, and then click OK.
    7. Click Next.
    8. Select vmnic1 and click Assign Uplink.
    9. Select LAG-FE-1 and click OK.
    10. Click Next > Next > Next > Finish.