The SFS UI is accessed by connecting to the IPv4 address of the SFS master switch.
Only one switch per SFS domain is the master, all other switches are backups. The master address is determined by running the show smartfabric cluster
command from the CLI of any switch in the SmartFabric domain. Each domain has its own master switch.
Note: After reloading the switches, it takes a few minutes for SFS to come up and for the IP address to be shown in the command output. The ROLE shown is the role for the local switch and is either MASTER or BACKUP. The MASTER-IPV4 address is the same on all switches in the domain.
Site 1 (domain 100) example:
S1-Leaf1A# show smartfabric cluster
----------------------------------------------------------
CLUSTER DOMAIN ID : 100
VIP : fde2:53ba:e9a0:cccc:0:5eff:fe00:1100
ROLE : BACKUP
SERVICE-TAG : 7B3ZZP2
MASTER-IPV4 : 100.67.128.33
PREFERRED-MASTER :
----------------------------------------------------------
In the example above, switch S1-Leaf1A is a backup in domain 100. The IP address of the master is 100.67.128.33.
Site 2 (domain 101) example:
S2-Leaf1A# show smartfabric cluster
----------------------------------------------------------
CLUSTER DOMAIN ID : 101
VIP : fde2:53ba:e9a0:cccc:0:5eff:fe00:1101
ROLE : MASTER
SERVICE-TAG : 7BVB9Z2
MASTER-IPV4 : 100.67.128.30
PREFERRED-MASTER :
----------------------------------------------------------
In the example above, switch S2-Leaf1A is the master in domain 101. The IP address of the master is 100.67.128.30.
To connect to the SFS UI, perform the following steps: