Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
SmartFabric Services with Multisite vSAN Stretched Cluster Deployment Guide
Notes, cautions, and warnings Introduction Hardware Used in this Guide Topology Deployment Planning SFS switch configuration Configure DCI switches Configure Fabric Interconnects Configure Networks Add ESXi hosts to topology Configure a jump host Deploy the DNS server and the vCenter Server ESXi services and witness host configuration Deploy the vSAN Stretched Cluster Migrate the vCenter Server and the DNS server Add User VMs
Add User VMs
Create Distributed Port Group
Deploy VMs
Verify connectivity
Deploy OMNI Validated Components Technical Resources CLI Command Output

Add User VMs

Home > Networking Solutions > Converged and Hyperconverged Solutions > vSAN Networking Solutions > Guides > SmartFabric Services with Multisite vSAN Stretched Cluster Deployment Guide > Add User VMs

Add User VMs

  • In this optional chapter, two user VMs are added to the environment and connected to the network named VM Data.

    In the preceding sections of this guide, an optional network named VM Data was configured on the SFS switches using the settings in the following table.

     Table 12.  Existing VM Data network configuration on SFS switches 
    VLAN IDDescriptionSFS network NameNetworkGateway
    20VM Datavmdata-20192.168.20.0/24192.168.20.254