Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
SmartFabric Services with Multisite vSAN Stretched Cluster Deployment Guide
Notes, cautions, and warnings Introduction Hardware Used in this Guide Topology Deployment Planning
Minimum requirements
Unsupported features
Networks and IP addresses
BGP ASNs and router IDs
DNS server records
SFS default fabric settings
SFS switch configuration Configure DCI switches Configure Fabric Interconnects Configure Networks Add ESXi hosts to topology Configure a jump host Deploy the DNS server and the vCenter Server ESXi services and witness host configuration Deploy the vSAN Stretched Cluster Migrate the vCenter Server and the DNS server Add User VMs Deploy OMNI Validated Components Technical Resources CLI Command Output

BGP ASNs and router IDs

Home > Networking Solutions > Converged and Hyperconverged Solutions > vSAN Networking Solutions > Guides > SmartFabric Services with Multisite vSAN Stretched Cluster Deployment Guide > BGP ASNs and router IDs

BGP ASNs and router IDs

  • BGP autonomous system numbers (ASNs) and router IDs are manually configured on the DCI site switches in this deployment. The values used are shown in the table below.

    Table 3. DCI switch router ID and ASNs
    Switch Router ID ASN
    DCI-Site-1 10.0.1.1/32 65101
    DCI-Site-2 10.0.2.1/32 65102
    DCI-Site-3 10.0.3.1/32 65103
    Note: SFS automatically configures ASNs and router ID addresses on the SmartFabric switches.