Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
SmartFabric Storage Software Deployment Guide
Introduction Network Planning Overview of Example Deployment Configure the IP network Configure ESXi NVMe/TCP hosts Configure SUSE Linux Enterprise Server NVMe/TCP hosts Configure PowerStore subsystems
Configure PowerStore subsystems
PowerStore initial state
PowerStore Storage Networks
Configure PowerMax subsystems Deploy SFSS on ESXi Deploy SFSS on Linux KVM Configure SFSS Establish NVMe/TCP between Endpoints Configure guest virtual machines Hardware and Software Used in this Guide Manual discovery, registration, and verification Additional Configuration and Settings Information Additional Information on ESXi NVMe/TCP Hosts Additional information on Linux NVMe/TCP hosts Troubleshooting Technical resources

Configure PowerStore subsystems

Home > Networking Solutions > Storage Networking > Guides > SmartFabric Storage Software Deployment Guide > Configure PowerStore subsystems

Configure PowerStore subsystems


  • Before proceeding with configuring PowerStore subsystems review the PowerStore network requirements section in the Network Planning chapter.

    Based on your solution, select the appropriate method of discovery and go to the resulting configuration step in the guide.

    Figure 76. PowerStore discovery options

    The default NVMe Discovery Options setting in PowerStore 3.0 is Automated discovery.