Home > Networking Solutions > Enterprise/Data Center Networking Solutions > Enterprise SONiC Networking Solutions > Guides > Dell Technologies Enterprise SONiC Edge with Cisco ISE > Endpoint setup
By default, dox1x authentication is not enabled on Windows 10 network interface service. Use the following steps to enable it.
Use default configurations when configuring the Cisco IP phone. EAP-TLS authentication is the default.
PoE IP Camera does not support full stack dot1x authentication, use MAB as alternative. No additional configuration is required.
The Dell SONiC Switch used in this setup is the following:
Cisco ISE was installed and configured as a Virtual Machine (VM) running inside VMware ESXi hypervisor. ESXi is running on a Dell PE server. In production deployment, consider hardening and clustering ISE deployment so that ISE will not be a single failure point.
Note: It is important to keep ISE running all the time. If ISE is not running, dot1x enabled network interfaces can not be authenticated will remain in locked-up status.