Home > Networking Solutions > Enterprise/Data Center Networking Solutions > Enterprise SONiC Networking Solutions > Guides > Dell Technologies Enterprise SONiC Edge with Cisco ISE > Dell PE Server Windows OS Dot1x Endpoint
In the Dell SONiC Edge bundle switch, run the following command to verify the deployment or run this command to show all endpoints connection status to restart the authentication. Run port shut/no shut by connecting or disconnecting the cable to the port.
Note: This is a VLAN so the switch configuration does not have the config for it, but it does have an entry in the switch VLAN database.
This VLAN is specified in Cisco ISE dot1x policy set.
Scroll down in the the Common Tasks section to open the specified VLAN.
The port status is available in Windows OS control panel.
The MAC address matches the one in switch verification result.
Use the following steps to verify and test the created policy sets.
Follow these steps to bring up Live RADIUS sessions.
Figure 152. Drop down menu for RADIUS Live Sessions
Figure 154. Windows endpoint live session
Use the following command to verify the deployment in the Dell SONic Edge bundle switch or run this command to show all endpoints connection status to restart the authentication. Run port shut/no shut by connecting or disconnecting the cable to the port.
Note: This is a dynamic VLAN, so the switch configuration does not have the config for it, but it does have an entry in the switch VLAN database.
This VLAN is specified in Cisco ISE dot1x policy set, Results Profile Cisco_IP_Phones_Dell_SW. In Common Tasks go to the VLAN specified.
To verify and test the created policy sets. Go to ISE Operation menu to bring up RADIUS Live logs. Click Operations > RADIUS > Live Logs drop down menu.
This dot1x endpoint is authenticated through Extensible Authentication Protocol-Transport Layer Security (EAP-TLS). ISE automatically creates an identity based on Cisco IP model and MAC address with the name: CP-8841- SEPF0B2E58FC22F.
From Dell SONiC Edge bundle switch side, run the following command to verify the deployment or run this command to show all endpoints connection status. To restart the authentication, run port shut/no shut by physically disconnecting and connecting the cable to the port.
Figure 173. Cisco IP Phone endpoint log for RADIUS authentication
Note: This is a dynamic VLAN, so the switch configuration does not have the config for it, but it does have an entry in the switch VLAN database
This VLAN is specified in Cisco ISE dot1x policy set, Figure 140, Results Profile Dell_SONIC_MAB, In Figure 54, Common Tasks section, scroll down, it has this VLAN specified.
Figure 176. Result Profile for MAB endpoint with VLAN