The following configuration examples are for the ToR switch pair. The configuration is limited to the minimum basic interfaces and features for connecting to the MX fabric on the Z9432F-ON switch pair.
Note: The interface numbers and VLANs used in these example configurations are arbitrary. Change the configuration details to suit your deployment requirements.
Configure global switch settings
Configure the switch hostname, OOB management IP address, OOB management default gateway, and NTP server IP address.
configure terminal
hostname S5232-1
interface mgmt 1/1/1
no ip address dhcp
ip address 100.67.XX.XX/24
no shutdown
ipv6 address autoconfig
management route 0.0.0.0/0 100.67.XX.XX
ntp server 100.67.XX.XX
| configure terminal
hostname S5232-2
interface mgmt 1/1/1
no ip address dhcp
ip address 100.67.YY.YY/24
no shutdown
ipv6 address autoconfig
management route 0.0.0.0/0 100.67.YY.YY
ntp server 100.67.YY.YY
|
Configure VLTi
For this example deployment, interfaces Ethernet 1/1/29 and 1/1/31 are configured as VLTi ports.
configure terminal
interface ethernet1/1/29
description VLTi
no shutdown
no switchport
flowcontrol receive off
interface ethernet1/1/31
description VLTi
no shutdown
no switchport
flowcontrol receive off
vlt-domain 1
backup destination 100.67.XX.XX
discovery-interface ethernet1/1/29,1/1/31
peer-routing
| configure terminal
interface ethernet1/1/29
description VLTi
no shutdown
no switchport
flowcontrol receive off
interface ethernet1/1/31
description VLTi
no shutdown
no switchport
flowcontrol receive off
vlt-domain 1
backup destination 100.67.YY.YY
discovery-interface ethernet1/1/29,1/1/31
peer-routing
|
Configure downstream interfaces
To configure downstream interfaces, perform the following steps:
- Configure the port group for the ethernet interfaces connected to the downstream Z9432F-ON switches.
- Create the in-band production VLANs. A single VLAN-1811 is created for this example and is configured as an access VLAN on port-channel 10. Interface ports 1/1/9 and 1/1/10 are configured as a member of port-channel 10.
- Save the running-config to the start-up config.
configure terminal
interface vlan1811
no shutdown
interface port-channel10
description To-Z9432
no shutdown
mtu 9216
switchport mode access
switchport access vlan 1811
interface range ethernet1/1/9-1/1/10
description To-Z9432
no shutdown
channel-group 10 mode active
no switchport
mtu 9216
flowcontrol receive off
flowcontrol transmit on
write memory
| configure terminal
interface vlan1811
no shutdown
interface port-channel10
description To-Z9432
no shutdown
mtu 9216
switchport mode access
switchport access vlan 1811
interface range ethernet1/1/9-1/1/10
description To-Z9432
no shutdown
channel-group 10 mode active
no switchport
mtu 9216
flowcontrol receive off
flowcontrol transmit on
write memory
|