Ensure the physical VLTi connections are made between leaf pairs before proceeding.
To put the first pair of leaf switches in SmartFabric mode and configure them as VLT peers, run the following commands on each switch:
OS10# configure terminal
OS10(config)# smartfabric l3fabric enable role LEAF vlti ethernet 1/1/49-1/1/52
Reboot to change the personality? [yes/no]:yes
To put the spine switches in SmartFabric mode and configure them as VLT peers, run the following commands on each switch:
OS10# configure terminal
OS10(config)# smartfabric l3fabric enable role SPINE
Reboot to change the personality? [yes/no]:yes
The configuration is applied, and the switches reload.To verify that the switches are in SmartFabric mode, after the switches are back online, run the following command on each switch:
OS10# show switch-operating-mode
Switch-Operating-Mode : Smart Fabric Mode