To connect to the SFS UI, perform the following steps:
- From a workstation with access to the OOB management network, use a browser to connect to the management IP address of either leaf switch by going to https://switch_mgmt_ip_address .
- Log in as admin. The default password is admin. Note: After reloading the switches, it takes a few minutes for SFS to come up and for the UI to be fully functional.
Note: The SFS UI supports the Google Chrome, Mozilla Firefox, and Microsoft Edge browsers. Languages other than English are currently not supported.
All SFS UI configuration is performed on the SFS leader switch. If you connect to an SFS switch that is not the leader, a link to the leader is provided. This is outlined in red in the figure below.
- If applicable, click the link provided to go to the leader switch, and log in as admin. Note: The IPv4 address of the SFS leader may also be determined by running the show smartfabric cluster command from the CLI of any switch in the SmartFabric.
When connected to the SFS leader switch, the Summary > Overview page displays.
The Device Status box shows there are six switches online in the SmartFabric.
- Click the Topology tab. The current topology displays with the leader identified, as shown.