If not already done, configure an IP address on the management interface of each leaf and spine switch. If routing is used on the OOB management network, also configure a management route.
This is done on each switch as follows:
OS10# configure terminal
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 100.67.76.30/24
OS10(conf-if-ma-1/1/1)# no shutdown
OS10(conf-if-ma-1/1/1)# exit
OS10(config)# management route 100.67.0.0/16 100.67.76.254
OS10(config)# end
OS10# write memory
% Error: ZTD is in progress(configuration is locked)
is preventing entry into configuration mode, enter the command ztd cancel
to proceed. Other global settings may also be configured here, such as ip name-server
and ntp server
if used by the switch. These settings may also be configured later in the SFS UI but are not required for the deployment example in this guide. The hostname of the switch may be configured at the CLI or in the SFS UI. In this guide, the SFS UI is used.