Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10 release 10.5.3.0.44
Introduction Hardware overview Leaf-spine overview Protocols in the leaf-spine example Layer 3 configuration planning Layer 3 with Dell leaf and spine switches OSPF and eBGP Alternate use case scenario
Introduction
Delay-restore for Orphan port (VLT domain)
BFD tracking support VRRP groups in eBGP (non-VLT Domain)
VRRP interface state object tracking (non-VLT Domain)
Demonstration Appendix A

Delay-restore for Orphan port (VLT domain)

Home > Networking Solutions > Enterprise/Data Center Networking Solutions > SmartFabric OS10 Networking Solutions > Guides > Dell Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10 release 10.5.3.0.44 > Delay-restore for Orphan port (VLT domain)

Delay-restore for Orphan port (VLT domain)

  • Figure 15.    Dual homed server in VLT deployment

    A ESXi host adopts an independent NIC teaming without port channel in VLT deployment, The respective Ethernet port 1/1/5 on Leaf and Leaf 2 are configured Delay-restore for Orphan port requirement under VLT domain 1.

    To enable the vlt delay-restore orphan-port on each of leaf switches with its setting 150 seconds to cater for the following scenario occurs.

    Leaf1

    Leaf2

    configure terminal

    interface Ethernet 1/1/5

    vlt delay-restore orphan-port enable

    exit

    vlt-domain 1

    delay-restore 150

     

     

    configure terminal

    interface Ethernet 1/1/5

    vlt delay-restore orphan-port enable

    exit

    vlt-domain 1

    delay-restore 150

     

     

    Leaf1 and Leaf2

    Leaf1#show vlt 1 delay-restore-orphan-ports

    VLT Delay-Restore timer           : 150 seconds

    Delay-Restore Orphan-Ports enabled interfaces  : Eth1/1/5

    Delay-Restore Orphan-Ports Ignore VLTi Fail enabled interfaces : N/A