Dell networking ONIE switch factory default settings | Dell Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10 release 10.5.3.0.44 | Dell Technologies Info Hub

Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below

Dell networking ONIE switch factory default settings

Dell networking ONIE switch factory default settings

Thank you for your feedback!

Note: This set of instructions brings ONIE switches to their factory default settings, which includes removing the operating system. If only removing the configuration is desired, this can be achieved with delete startup-config proceeded with reload.
All Dell Networking ONIE switches in this guide can be reset to factory defaults with the following instructions:
1. Reboot the switch
1. Use the up down arrows to select ONIE: Rescue and then press Enter. The highlighted entry (*) runs automatically in the operating system.
+--------------------------------------+
|*ONIE: Install OS |
| ONIE: Rescue |
| ONIE: Uninstall OS |
| ONIE: Update ONIE |
| ONIE: Embed ONIE |
| ONIE: Diag ONIE |
+--------------------------------------+
1. Press Enter again to enable the console
2. Use the onie-uninstall command to return to the default ONIE settings.
ONIE:/ # onie-uninstall Erasing unused NOR flash region
Erasing 128 Kibyte @ 20000 - 100% complete. Erasing internal mass storage device: /dev/mmcblk0 (7832MB) Percent complete: 100%