Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Multitenancy using VRF with Dell SmartFabric OS10 Implementation Guide
Introduction Multitenancy Use Cases Validated Components Switch Configurations Validate Configurations
Overview
Verify the OSPF configuration
Verify the VRFs and VLAN interfaces configurations
Verify the VLAN interfaces statuses
Verify the VLAN and loopback interfaces statuses
Confirm OSPF neighbors connectivity
View the routing tables
Validate Connectivity Route Leaking Summary Technical Resources

Verify the VLAN interfaces statuses

Home > Networking Solutions > Enterprise/Data Center Networking Solutions > SmartFabric OS10 Networking Solutions > Guides > Multitenancy using VRF with Dell SmartFabric OS10 Implementation Guide > Verify the VLAN interfaces statuses

Verify the VLAN interfaces statuses

  • View the status of each VLAN interface. They are trunked over Ethernet interface 1/1/49. Use the following commands:

    • show vlan 10
    • show vlan 20
    • show vlan 30
    • show vlan 100
    • show vlan 200
    • show vlan 300

    Rack 1 switch

    Rack-1# show vlan 200

     

    Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,

           @ - Attached to Virtual Network, P - Primary, C - Community, I - Isolated,

           S - VLAN-Stack VLAN

    Q: A - Access (Untagged), T - Tagged

        NUM    Status    Description                     Q Ports

        200    Active                                    T Eth1/1/49

     

     

    Rack-1# show vlan 300

     

    Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,

           @ - Attached to Virtual Network, P - Primary, C - Community, I - Isolated,

           S - VLAN-Stack VLAN

    Q: A - Access (Untagged), T - Tagged

        NUM    Status    Description                     Q Ports

        300    Active                                    T Eth1/1/49