CAUTION: The following commands delete the existing switch configuration. Switch management settings such as management IP address, management route, hostname, NTP server, and IP name server are retained.
Ensure the physical VLTi connections are made between leaf pairs before proceeding.
Note: This example uses the two QSFP28 2x 100 Gb DD ports, interfaces 1/1/49-1/1/52, for the VLTi connections on each S5248F-ON leaf.
To put the first pair of leaf switches in SmartFabric mode and configure them as VLT peers, run the following commands on each switch:
OS10# configure terminal
OS10(config)# smartfabric l3fabric enable role LEAF vlti ethernet
1/1/49-1/1/52
Reboot to change the personality? [yes/no]:yThe configuration is applied, and the switches reload.
To verify that switches are in SmartFabric mode, run the following command on each switch:
OS10# show switch-operating-mode
Switch-Operating-Mode : Smart Fabric Mode Note: For more information, see the OpenManage Network Integration User Guide, Release 3.2. The guide is available on the Dell OpenManage Network Integration website. For additional SmartFabric CLI commands, see the SmartFabric Services User Guide on the SmartFabric OS10 Documentation page.