Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Multitenancy using VRF with Dell SmartFabric OS10 Implementation Guide
Introduction
Solution introduction
Implementation Guide introduction
Document purpose
Revision history
Multitenancy Use Cases Validated Components Switch Configurations Validate Configurations Validate Connectivity Route Leaking Summary Technical Resources

Document purpose

Home > Networking Solutions > Enterprise/Data Center Networking Solutions > SmartFabric OS10 Networking Solutions > Guides > Multitenancy using VRF with Dell SmartFabric OS10 Implementation Guide > Document purpose

Document purpose

  • This guide shows how to configure and validate VRF on Dell S5248F-ON switches running Dell SmartFabric OS10 software. This guide is not meant to supply a comprehensive overview of all options and features available for VRF.

    For more information about additional features and options for VRF on Dell SmartFabric OS10 software, see the Dell SmartFabric OS10 User Guide Release 10.5.4.

    The steps in this guide were validated using the specified Dell Technologies PowerSwitch model and OS10 version. You can use these steps for other PowerSwitch models with similar port types that support the OS10 version or later used here.

    Goals

    This guide shows you how to:

    • Configure VRF instances on Dell S5248F-ON switches using VRF CLI commands.
    • Demonstrate multitenancy and route leaking.
    • Validate configuration and verify connectivity.

    Resources

    The resources that are used include:

    • Two Dell S5248F-ON PowerSwitch networking switches
    • Dell SmartFabric OS10 version 10.5.4.6