This section covers the BGP CLI commands on OS10 and SONiC. BGP is the routing protocol used in the following example for the underlay fabric.
Dell SmartFabric OS10 | Dell Enterprise SONiC |
conf t bfd enable exit conf t interface Eth1/1/3 ipv6 nd max-ra-interval 4 ipv6 nd min-ra-interval 3 ipv6 nd send-ra no shut conf t ip prefix-list spine-leaf seq 10 permit 10.0.0.0/16 ge 24 route-map spine-leaf permit 10 match ip address prefix-list spine-leaf exit router bgp 64625 router-id 10.0.2.1 bestpath as-path multipath-relax maximum-paths ebgp 2 graceful-restart role receiver-only address-family ipv4 unicast redistribute connected route-map spine-leaf exit template spine-leaf fall-over advertisement-interval 1 timers 3 9 exit neighbor interface Eth 1/1/3 remote-as 65000 inherit template spine-leaf send-community extended update-source loopback0 address-family ipv4 unicast no activate exit address-family l2vpn evpn activate allowas-in 1 end
| conf t ip prefix-list spine-leaf seq 10 permit 10.0.2.0/24 ge 32 route-map spine-leaf permit 10 match ip address prefix-list spine-leaf exit router bgp 2001 router-id 10.0.2.1 bestpath as-path multipath-relax address-family ipv4 unicast redistribute connected maximum-paths 16 maximum-paths ibgp 1 exit address-family l2vpn evpn advertise-all-vni advertise-pip ip 10.0.2.1 exit neighbor interface Eth 1/3 peer-group spine-leaf remote-as external timers 3 9 timers connect 30 advertisement-interval 0 bfd capability extended-nexthop address-family ipv4 unicast activate allowas-in 2 send-community both exit address-family l2vpn evpn activate allowas-in 2 end
|