Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Tech Book—Dell Integrated System For Microsoft Azure Stack HCI
Preface Business Transformation and Data Center Modernization Evolution of Data Centers to HCI and Hybrid Cloud A Closer Look at Microsoft Azure Stack HCI Azure Stack HCI Architecture and Building Blocks Dell Integrated System for Microsoft Azure Stack HCI Portfolio – AX Nodes Networking Topologies for Azure Stack HCI Solutions
Networking Topologies for Azure Stack HCI Solutions
Overview
Scalable
Switchless storage
Switch Embedded Teaming (SET)
Remote Direct Memory Access
Scalable architecture for Dell Solutions for Azure Stack HCI
Fully converged network configuration
Non-converged network configuration
Switchless storage networking
Single-link full mesh topology
Dual-link full mesh topology
2-node back-to-back connected architecture
3-node single-link full mesh switchless interconnect
Single-node clusters
PowerSwitch model options for scalable infrastructure
iWARP vs RoCE for RDMA
Dell Fabric Design Center
Stretch Clustering with Azure Stack HCI Managing the Hybrid Cloud Sizing and Configuration Best Practices Dell Support and Services Conclusion Additional Resources

Non-converged network configuration

Home > Integrated Products > Microsoft HCI Solutions from Dell Technologies > Guides 22H2 and earlier > Tech Book—Dell Integrated System For Microsoft Azure Stack HCI > Non-converged network configuration

Non-converged network configuration

  • In non-converged network configurations, the storage traffic is separated from the management/VM traffic using dedicated storage network adapters. The storage traffic can either be on the physical ports or implemented as virtual adapters in the host operating system that is connected to a switch embedded team (SET). The following figure shows this network integration option.

    Figure 37. Network integration in a non-converged configuration with two NIC ports