Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell PowerSwitch SmartFabric OS10 with Cisco ACI Deployment Guide
Introduction Hardware overview Cisco Application Centric Infrastructure (ACI) Dell ToR switches with Cisco ACI environment overview OOB Management network Cisco APIC configuration Configure S5248F-ON switches
OOB management configuration
VLT configuration
Configure the VLANs
Server-facing configuration
Switch pair uplink configuration
vCenter configuration overview Verify configuration Additional information Validated components Additional resources

OOB management configuration

Home > Networking Solutions > Enterprise/Data Center Networking Solutions > SmartFabric OS10 Networking Solutions > Guides > Dell PowerSwitch SmartFabric OS10 with Cisco ACI Deployment Guide > OOB management configuration

OOB management configuration

  • The OOB port for the Dell PowerSwitch S5248F-ON is mgmt 1/1/1. The following commands show how to configure this OOB port when using Dell SmartFabric OS10. The switches start at their factory default settings as described in Reset Dell SmartFabric OS10 switches to factory defaults.
    Note: The S5248F-ON CLI is accessible through the console port or by using SSH. The default username and password are both admin.

    Table 4. OOB management configuration
    S5248F-1 S5248F-2 
    configure terminal 
     
    hostname S5248F-1 
     
    interface mgmt 1/1/1  no ip address dhcp  
    no shutdown 
    ip address 100.67.166.33/24 
     
    management route 0.0.0.0/0 
    100.67.166.254 
    configure terminal 
     
    hostname S5248F-2 
     
    interface mgmt 1/1/1  no ip address dhcp  
    no shutdown 
    ip address 100.67.166.32/24 
     
    management route 0.0.0.0/0 
    100.67.166.254
    Note: The configuration for the S3048-ON management switch is not shown. The configuration and deployment of the overall management network is not within this document's scope.