To verify that Fabric Management Address is in LLDP Protocol Data Units (PDUs) in SmartFabric mode, perform the following steps on the OME-M Console.
- Open the OME-M console and select Devices > Fabric.
- Select the SmartFabric to verify, then select Edit.
- Ensure that the checkbox next to the Include Fabric Management Address in LLDP Messages option is selected, then click Finish.
To verify that Fabric Management Address is in LLDP Protocol Data Units (PDUs) in Full Switch mode, run the show running-configuration command on the OS10 CLI. Ensure that the output includes the lldp management-addr-tlv ipv4 virtual-ip command as one of the listed commands. If it is not configured, perform the below steps.
- SSH to the OS10 CLI on the switch.
- Run the following command on all the IOMs within the fabric:
MX9116n-1# configure terminal
- If the switch running the configuration shows that the LLDP is not enabled, run the lldp enable command:
MX9116n-1<config># lldp enable
- Run the lldp management-addr-tlv ipv4 virtual-ip command to include the Fabric Management Address in LLDP messages:
MX9116n-1<config># lldp management-addr-tlv ipv4 virtual-ip
- Exit and save the configuration by running the following commands:
MX9116n-1<config># exit
MX9116n-1<config># write memory