In Full Switch mode, all SmartFabric OS10 features and functions supported by the hardware are available to the user. The MX switch will operate the same way as any other SmartFabric OS10 switch. Configuration is primarily done through the CLI; however, the following items can be configured or managed using the OME-M user interface:
- Initial switch deployment: Configure hostname, password, SNMP, NTP, and so on
- Set ports administratively up or down, configure MTU
- Monitor health, logs, alerts, and events
- Update the SmartFabric OS10 software
- View physical topology
- Switch power management
Full Switch mode is typically used when a wanted feature or function is not available when operating in SmartFabric Services mode. For more information about Dell SmartFabric OS10 operations, see the Dell SmartFabric OS10 User Guide on the Documentation page of the support site.