Home > Networking Solutions > Enterprise/Data Center Networking Solutions > Enterprise SONiC Networking Solutions > Guides > EVPN-VxLAN based Multisite Data Center Interconnect (DCI) using Dell Enterprise SONiC > Show command output from Fabric-A-Spine1
Use the following commands to see the LLDP table and the configuration of interfaces.
Fabric-A-Spine1# show ipv6 interfaces Flags: U-Unnumbered interface, A-Anycast IP ----------------------------------------------------------------------------------------------------------------- Interface IP address/mask VRF Admin/Oper Flags ----------------------------------------------------------------------------------------------------------------- eth0 fe80::6e2b:59ff:fefc:1320/64 mgmt up/up Ethernet168 fe80::6e2b:59ff:fefc:1324/64 up/up Ethernet192 fe80::6e2b:59ff:fefc:1324/64 up/up |
Fabric-B-Spine1# show ip interfaces Flags: U-Unnumbered interface, A-Anycast IP ----------------------------------------------------------------------------------------------------------------- Interface IP address/mask VRF Admin/Oper Flags ----------------------------------------------------------------------------------------------------------------- eth0 172.17.100.44/24 mgmt up/up Loopback0 10.0.1.0/32 up/up
|
Fabric-A-Spine1# show bgp ipv4 unicast summary BGP router identifier 10.0.1.0, local AS number 65000 VRF default Neighbor V AS MsgRcvd MsgSent InQ OutQ Up/Down State/PfxRcd Ethernet168 4 65001 66 65 0 0 00:19:07 2 Ethernet192 4 65012 64 64 0 0 00:18:12 9 Total number of neighbors 2 Total number of neighbors established 2
|
Fabric-A-Spine1# show bgp l2vpn evpn summary BGP router identifier 10.0.1.0, local AS number 65000 VRF default Neighbor V AS MsgRcvd MsgSent InQ OutQ Up/Down State/PfxRcd Ethernet168 4 65001 67 66 0 0 00:20:13 0 Ethernet192 4 65012 65 65 0 0 00:19:18 0 Total number of neighbors 2 Total number of neighbors established 2
|
:
A similar configuration is required for Fabric B, as shown in the following table:
Fabric-B-Leaf1 | Fabric-B-Spine1 | Fabric-B-BL1 |
configure terminal | configure terminal bfd | configure terminal |