Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Validation Guide—PowerStore Configuration and Deployment Best Practices for SAP HANA TDI
PowerStore storage configuration
Overview Front-end I/O modules PowerStore disk storage Data reduction Volumes SAP HANA capacity requirements

PowerStore storage configuration

Front-end I/O modules

  • All PowerStore models have the same connectivity options. The following figure shows these connectivity options as seen from the back-end:

    Figure 4.                  PowerStore T back-end view

    PowerStore node A is the bottom node, while PowerStore node B is the top node. Each node has one embedded module (red squares) with management and SAS expansion ports and a four-port Mezzanine card for connections such as NAS or cluster interconnects. This card can be used for NAS (NFS) and the SAP HANA shared file system (/hana/shared).

    Each node has two additional slots for four-port I/O modules (green square). These slots must be used for SAP HANA client FC connections, either 16 Gb/s or 32 Gb/s FC.

next

PowerStore disk storage