Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Validation Guide—Dell EMC VxRail Hyperconverged Infrastructure on SAP HANA

close

view all chapters

Appendix A: Deploying Dell EMC Networking SmartFabric Services with VxRail HCI
Deploying Dell EMC Networking SmartFabric Services with VxRail HCI—Introduction SFS profile personalities SmartFabric Service with VxRail nodes Supported switches Unsupported environments Unsupported features Topology deployment options Uplink options External switches OpenManage Network Integration

OpenManage Network Integration

OpenManage Network Integration

  • OpenManage Network Integration enables configuration and management of Dell EMC PowerSwitch systems that are running SmartFabric OS10 within the vCenter. With OpenManage Network Integration, networks that are created in vCenter are automatically configured in the fabric.

    Using the OpenManage Network Integration plug-in in vCenter, you can perform the following tasks:

    • View the leaf-spine topology
    • View the switch status
    • Configure server-facing interfaces and port channels
    • Configure uplinks to external networks
    • Create networks
    • Configure routing
    • Upgrade SmartFabric OS10

    Network creation for SAP HANA

    OpenManage Network Integration provides a way to easily and automatically create networks for SAP HANA. The plug-in enables the VMware administrator to administer the network with no more than a basic understanding of the network. Administrators can use SFS APIs to further automate a network configuration.

    The figures in this section show how to create SAP HANA networks using OpenManage Network Integration.

    The example shown in Figure 17 assumes that the following networks are needed for the SAP HANA landscape:

    • SAP HANA management network: VLAN ID 1814 – Layer 3
    • SAP HANA production network: VLAN ID 1815 – Layer 3
    • SAP HANA internal network: VLAN ID 1816 – Layer 2

    Graphical user interface, diagram Description automatically generated

    Figure 17.          SAP HANA network requirements

    Using OpenManage Network Integration, you can create or modify Layer 2 or Layer 3 networks for the SAP HANA landscape. An SAP HANA internal network requires a Layer 2 network. SAP HANA management and production networks require a Layer 3 network because they must be routed to an external network. Creating or modifying the networks using OpenManage Network Integration is simple because OpenManage Network Integration is embedded in vSphere vCenter, as shown in the following figure:

    Table Description automatically generated