Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
PowerScale: Network Design Considerations
Executive summary Network architecture design Latency, bandwidth, and throughput Ethernet flow control SyncIQ considerations Quality of Service (QoS) Software-Defined Networking PowerScale OneFS ports SmartConnect considerations Ethernet, MTU, and IP overhead
Introduction
Ethernet packet
Ethernet payload
Jumbo frames
IP packet overhead
Data payload to Ethernet frame efficiency
ICMP and MTU with OneFS
OneFS MTU commands
VLAN and interface MTU
Confirming transmitted MTU
Access Zones best practices Source-Based Routing considerations Isilon 6th generation 1 GbE interfaces Intelligent Platform Management Interface IPv6 OneFS host-based firewall Network troubleshooting Appendix A: Supported network optics and transceivers Appendix B: Technical support and resources

OneFS MTU commands

OneFS MTU commands

  • To check the current configured MTU, enter the following command:

    isi networks subnets list –v

    To modify the MTU, use the isi command with the following context:

    isi network subnets modify groupnet0.subnet1 --mtu=1500 --gateway=198.162.100.10

    --gateway-priority=1