Scalable Architecture with Network ATC

Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below

Thank you for your feedback!

To configure an Azure Stack HCI networking environment using Network ATC one must create the cluster and then configure host networking using Network ATC. We would enable S2D as a final step.

This is a deviation from the legacy procedure where host networking was the first step, followed by cluster creation.

The following documents provide instructions to configure top-of-rack networking switches:
- Microsoft HCI Solutions from Dell Technologies:Switch Configurations, iWARP Mellanox (RoCE)and Intel E810 (iWARP) Cards
- Microsoft HCI Solutions from Dell Technologies:Switch Configurations, iWARP (Qlogic CardsOnly)
- Configure host networking
- Create a cluster
- Converged topology
- Non-converged topology
- Enabling Storage Spaces Direct
  After you create the cluster, run the Enable-ClusterS2D cmdlet to configure Storage Spaces Direct on the cluster. Do not run the cmdlet in a remote session; instead, use the local console session.
- Updating the page file settings
  To help ensure that the active memory dump is captured if a fatal system error occurs, allocate sufficient space for the page file. Dell Technologies recommends allocating at least 50 GB plus the size of the CSV block cache.
- Configuring a cluster witness
- Best practices and recommendations
  Dell Technologies recommends that you follow the guidelines that are described in this section.
- Enabling bit locker
  Bit locker is a drive encryption feature from Microsoft that is designed to protect the user data on a computer. Bit locker provides elevated protection when combined with hardware component called trusted platform module (TPM).
- Recommended next steps
  Before you proceed with operational management of the cluster, Dell Technologies recommends that you validate the cluster deployment, verify that the infrastructure is operational, and, if needed, activate the operating system license.