Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
E2E Deployment and Operations Guide with Scalable Networking: Microsoft HCI Solutions from Dell Technologies
Deployment Introduction Solution Overview Solution Deployment Scalable Architecture with Network ATC
Scalable Architecture with Network ATC
Fully converged network configuration
Non-converged network configuration
Storage on physical adapters
Create a cluster
Converged topology
Non-converged topology
Enabling Storage Spaces Direct
Updating the page file settings
Configuring a cluster witness
Best practices and recommendations
Disable SMB Signing Update the hardware timeout for the Spaces port Enable jumbo frames
Enabling bit locker
Recommended next steps
GPU Integration Day 1 operations Managing and monitoring clusters with Windows Admin Center Dell OpenManage Integration with Windows Admin Center Updates and maintenance References

Non-converged network configuration

Non-converged network configuration

  • In the non-converged network configurations, storage traffic is separated from management/VM traffic using dedicated storage network adapters. The following figure depicts this network integration option.

    Figure 6. Network integration in a non-converged configuration with two NIC ports
    Figure showing network integration in a non-converged configuration with two NIC ports