Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Disaster Recovery for Dell PowerFlex using VMware Site Recovery Manager
Introduction Product overview Solution components Solution architecture
Solution architecture
Logical architecture
Create RCG
Create datastore
Install and configure SRM
Test recovery plan
Run recovery plan
Reprotect recovery plan
Case study Best practices Conclusion References

Create RCG

Create RCG

  • Following are the steps to add RCG:

    1. From the PowerFlex GUI, select Protection > RCGs > Add.
    2. Provide the RCG Name.
    3. Enter the RPO value in seconds or minutes.
    4. Select the Source Protection Domain, Target System, Target Protection Domain, and click Next.
    5. Select the volume from the Source column and then select a volume of the same size from the Target column.

    Note: The volume must be manually created or should be present at the target site.

    1. Click Add Pair and click Next.
    2. Review the details to ensure the correct source and target volume pairs are selected and click Add RCG & Start Replication.

    Graphical user interface, text, application Description automatically generated

    Figure 4.              RCG

    1. After creating the RCG, it must be mapped to relevant ESXi SDCs at the recovery site as read-only.