Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Deployment Guide—VMware IaaS on PowerEdge MX Servers and PowerMax Storage
Introduction Predeployment Requirements Physical Layout Network Configuration SAN Storage Deployment and Configuration
Introduction
Deploying PowerMax storage
Deploying Connectrix DS-6500 switches
Site survey example: FC port mappings
Zoning host servers to storage controllers
Adding cluster hosts to the storage array
Creating a LUN
Management Cluster Deployment Compute Cluster Deployment Management Software and Data Protection Deployment References Site Survey

Introduction

Introduction

  • This chapter describes the procedures that you must perform to deploy and configure the PowerMax storage array. It assumes that all storage equipment has been powered and connected to the appropriate networks. For enclosure cabling guidelines, see the Dell EMC PowerMax Family Site Planning Guide or consult your Dell EMC Sales representative.

    Note: PowerMax hardware cannot be installed by customers or Service Partners. Dell EMC Services must perform the initial installation.