Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Deployment Guide—Dell EMC Ready Stack for Red Hat OpenShift Container Platform 4.6
Deploying OpenShift 4.6
Introduction Creating a bootstrap KVM Installing control-plane nodes Completing the bootstrap setup Installing compute nodes Completing the cluster setup Removing the bootstrap node Accessing the OpenShift web console OpenShift license and support Configuring authentication Adding a compute node

Introduction

  • To create an OpenShift Container Platform cluster, first create a bootstrap KVM, then create the control-plane nodes, and finally create the compute nodes.

    Notes:
    This guide assumes that NIC in Slot 2 Port 1 is used for PXE installation. If necessary, replace the interface to suit your environment.
     

    All nodes must run in UEFI mode so that the playbooks running in the CSAH node work effectively.

next

Creating a bootstrap KVM