Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Deployment Guide—Dell EMC Ready Stack for Red Hat OpenShift Container Platform 4.3

close

view all chapters

Deploying OpenShift 4.3
Introduction Creating a bootstrap node Installing control plane nodes Installing worker nodes Completing the cluster setup Removing the bootstrap node Validating and approving Certificate Signing Requests Validating the cluster operators Accessing the OpenShift web console Configuring authentication Configuring image registry storage

Introduction

Introduction

  • To create an OpenShift Container Platform cluster, you must first create a bootstrap node, control plane nodes, and worker nodes in a specific order, as set out in this chapter.

    Note: The remainder of the document assumes that NIC in Slot 2 Port 1 is used for PXE installation. Replace the interface, if necessary, according to your setup.

    Note: All the nodes must be running in UEFI mode so that the playbooks that are run in CSAH node work effectively.