Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Deploying MX7000 CO Nodes and PowerFlex SO Nodes through Customer Switches
Introduction Hardware overview Network logical overview
Network logical overview
Two-layer configuration
Three-layer configuration
Lab Configuration and Validation Appendix A ─ Validated components Appendix B ─ Technical resources

Two-layer configuration

Two-layer configuration

  • The following figure provides a high-level overview of the topology that is used for two-layer architecture. The MX7000 compute nodes used the two-layer architecture to connect to the existing PowerFlex storage-only nodes. The same VLANs and subnets used for the storage network were extended across the entire two-layer network allowing unrouted communication between PowerFlex and MX7000.

    Figure 2.              Two-layer configuration