Home > Workload Solutions > SAP > Guides > SAP HANA TDI Guides > Dell Validated Solution for SAP HANA TDI Deployments with Dell Unity XT Storage > Front-end I/O modules
To achieve the maximum scalability in terms of SAP HANA nodes, as described in Table 2, configure all Unity XT arrays with two four-port FE I/O modules per storage processor (16 FE parallel ports per array). Further, ensure that the SAP HANA host connections are evenly distributed across all available FE ports and storage processors.
Depending on the Unity XT model, the rear view of the disk processing enclosure (DPE) varies, but all models have two I/O slots per storage processor. You can configure the slots with either four-port 16 Gb/s FC I/O modules or with four-port 10/25 Gb/s IP I/O modules. These I/O modules and ports must be dedicated to SAP HANA. The following figures show these I/O slots with a white square.
The Unity XT 380F model also has two integrated parallel ports per storage processor, which can either be 16/32 Gb/s FC or 10/25 Gb/s IP ports. The red squares in the following figure indicate the integrated parallel ports. The Unity XT 380F model has two integrated 10 Gb/s parallel ports, as indicated by the green squares.
Figure 3. Unity XT 380F back-end view
The Unity XT 480F, 680F, and 880F models also have two integrated four-port port I/O modules to support either 10 Gb/s or 25 Gb/s IP I/O modules. These ports are shown in the green squares in the following figure. You can also use these ports for SAP HANA, but they do not increase overall scalability, as defined in Table 2.
Figure 4. Unity XT 480F, 680F, 880F back-end view