In this section, you add the NSX networks to the VxRail server interface profiles for m01. Because the m01 NSX edges will be in Rack 1 in this example, the edge overlay and edge uplink networks are only added to the server profiles in Rack 1.
To add the NSX networks to the server profiles, select Server Interface > Server Interface in the SFS UI or OMNI.
Note: Before editing the profiles, sort the table by Interface Name by clicking the column header so that the interfaces are listed in order by leaf. Sorting makes it easier to assign the correct networks to the interface per the bulleted list above.
Note: Do not remove the interfaces from the existing networks required for VxRail.
On the Server Interface page, you can confirm each interface is in the correct networks by selecting the interface in the table on the left. The networks display on the lower right side of the screen.
Note: You can also confirm the interfaces are in the correct networks at the CLI of each leaf switch. Run the show vlan command for the NSX networks and the show virtual-network command for the remaining networks.