Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell Networking SmartFabric Services Deployment for VMware NSX-T 3.1
Notes, cautions, and warnings Introduction Hardware Overview Topology Deployment Planning Configure the VxRail Cluster VDS for NSX-T Traffic Deploy the NSX-T Manager Cluster Configure NSX-T
Configure NSX-T
Create transport zones
Create uplink profiles
Apply teaming policies
Create segments for uplink networks
Create a transport node profile
Configure VxRail nodes as host transport nodes
Deploy NSX Edge appliances
Create an NSX Edge cluster
Create VM/Host rules for NSX Edges
Create the Tier-0 gateway and configure BGP
Create a Tier-1 gateway
Create tenant segments
Register the NSX-T Manager Cluster with OMNI Use OMNI to Configure NSX-T Networks on Leaf Switches Add Tenant VMs Show Command Output Validated Components Additional Information

Create segments for uplink networks

Create segments for uplink networks

  • In this section, the uplink network segments in the following table are created.
     Table 10.  NSX-T segments 
    Segment nameTransport zoneVLANUplink teaming policy
    uplink-2711edge-uplink-tz2711uplink-1-teaming-policy
    uplink-2712edge-uplink-tz2712uplink-2-teaming-policy

    To create the uplink network segments, perform the following steps.

    1.  In the NSX Manager web UI, go to Networking > Segments. 
    2.  On the SEGMENTS tab, click ADD SEGMENT. 
    3.  For the first segment in the table above, enter the Segment Name, select the Transport Zone, enter the VLAN, and select the Uplink Teaming Policy from the drop-down list. 
    4.  Leave all other settings at their defaults and click SAVE. 
    5.  Click NO when asked if you want to continue configuring the segment. 

      Repeat steps 2 through 5 for the remaining segment in the table.

      When complete, the SEGMENTS tab appears as shown:

      Figure 24. Segments created
      Segments created