Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell Networking SmartFabric Services Deployment for VMware NSX-T 3.1
Notes, cautions, and warnings Introduction Hardware Overview Topology Deployment Planning Configure the VxRail Cluster VDS for NSX-T Traffic
Configure the VxRail Cluster VDS for NSX-T Traffic
Set the MTU and discovery protocol
Create the uplink port groups
Configure teaming and failover on the uplinks
Deploy the NSX-T Manager Cluster Configure NSX-T Register the NSX-T Manager Cluster with OMNI Use OMNI to Configure NSX-T Networks on Leaf Switches Add Tenant VMs Show Command Output Validated Components Additional Information

Configure teaming and failover on the uplinks

Configure teaming and failover on the uplinks

    1.  In the left pane, right-click on Uplink-01 and select Edit Settings. 

    2.  In the Edit Settings window, select Teaming and failover. 
      1.  Set Load balancing to  Route based on physical NIC load. 
      2.  Under Failover order, move uplink2 under Standby uplinks. 
        The screen appears as shown.
        Figure 10.  Uplink-01 teaming and failover settings configured
        Uplink-01 teaming and failover settings configured
      3.  Click OK. 
    3.  In the left pane, right-click on Uplink-02 and select Edit Settings. 
    4.  In the Edit Settings window, select Teaming and failover. 
      1.  Set Load balancing to Route based on physical NIC load. 
      2.  Under  Failover order, move uplink1 under Standby uplinks. 
        The screen appears as shown.
        Figure 11. Uplink-02 teaming and failover settings configured
        Uplink-02 teaming and failover settings configured
      3.  Click OK.