Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell Networking SmartFabric Services Deployment for VMware NSX-T 3.1
Notes, cautions, and warnings Introduction Hardware Overview Topology Deployment Planning Configure the VxRail Cluster VDS for NSX-T Traffic Deploy the NSX-T Manager Cluster Configure NSX-T Register the NSX-T Manager Cluster with OMNI Use OMNI to Configure NSX-T Networks on Leaf Switches Add Tenant VMs
Add Tenant VMs
Configuration of tenant VMs
Verification of connectivity
Traceflow reports
Show Command Output Validated Components Additional Information

Configuration of tenant VMs

Configuration of tenant VMs

  • For validation, four tenant VMs are deployed to different VxRail hosts. In this example, the VMs are configured as shown in the following table.

    Table 14. VM segment, address, and host configuration
    Host VM name Segment IP address Gateway DNS server
    vxrail01.dell.lab app-vm-01 app-segment 10.10.10.1/24 10.10.10.254 172.19.11.50
    vxrail02.dell.lab app-vm-02 app-segment 10.10.10.2/24 10.10.10.254 172.19.11.50
    vxrail03.dell.lab web-vm-01 web-segment 10.10.20.1/24 10.10.20.254 172.19.11.50
    vxrail04.dell.lab web-vm-02 web-segment 10.10.20.2/24 10.10.20.254 172.19.11.50
    Note: Tenant VM deployment is not covered in this guide.

    In the vSphere Client, the VM network adapter on each of the tenant VMs is assigned to the applicable segment per the previous table, as shown.

    Figure 51. app-vm-01 added to app-segment
    app-vm-01 added to app-segment

    IP address, gateway, and DNS server settings are configured in the operating system of each VM per the previous table.