Configure the hostname, OOB management IP address, and default gateway. Specify an NTP server accessible by the switch. The example shows an NTP server on the OOB management network with a different IP address than the one used by the VxRail nodes on the External Management network.
Note: Default spanning tree settings are used in this deployment. In SmartFabric OS10, RVPST+ is enabled by default, and RPVST+ VLAN priority numbers start at 32769. Modify the spanning tree settings if required for your environment. LLDP is enabled on each interface and globally by default. LLDP is useful for troubleshooting and validation. Dell Technologies recommends leaving it enabled.
Table 11.
General settings – dual switch with VLT
configure terminal
hostname S4148F-ExternalA
interface mgmt1/1/1
no ip address
ip address 100.67.128.40/24
no shutdown
management route 100.67.0.0/16 100.67.128.254
ntp server 100.67.10.20 |
configure terminal
hostname S4148F-ExternalB
interface mgmt1/1/1
no ip address
ip address 100.67.128.39/24
no shutdown
management route 100.67.0.0/16 100.67.128.254
ntp server 100.67.10.20 |