Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell EMC PowerProtect Cyber Recovery: Automated Recovery of PowerProtect Data Manager
Executive summary Introduction Prerequisites for a PowerProtect Data Manager Recovery
Production environment
Vault environment
PowerProtect Data Manager automated recovery using the Cyber Recovery UI Recovery check Post-recovery steps for a PowerProtect Data Manager Recovery Conclusion References

Vault environment

Vault environment

  • Ensure that your vault environment meets the following requirements:

    • Ensure the Cyber Recovery Vault DD series system is running DD Operating System (DDOS) version 6.2 or later.
    • Deploy the Cyber Recovery virtual appliance in the Cyber Recovery Vault environment and install the PowerProtect Data Manager application as the admin user.
    • Configure the UIDs that are associated with the production PowerProtect Data Manager DD Boost users in the Cyber Recovery Vault DD series system. These UIDs must be available in the DD series system in the Cyber Recovery Vault.

    For example, when a backup is completed using PPDM, the DD Boost user is automatically created in the production DD series appliance with a UID (for example, 528). When you initiate an automated recovery of PowerProtect Data Manager, Cyber Recovery attempts to create same DD Boost user on the vault DD series system with the same UID (528). If that UID is assigned to another user, recovery will fail. You must keep that UID available in the vault DD series system for a successful recovery.

    • Ensure the PowerProtect Data Manager virtual appliance is deployed which will be used as vault application. While adding PowerProtect Data Manager application in the Cyber Recovery Vault, configure it with the same credentials used for the PowerProtect Data Manager application on the production system.