Ensure the physical VLTi connections are made between leaf pairs before proceeding.
To put the first pair of leaf switches in SmartFabric mode and configure them as VLT peers, run the following commands on each switch:
OS10# configure terminal OS10(config)# smartfabric l3fabric enable role LEAF vlti ethernet 1/1/49-1/1/52 Reboot to change the personality? [yes/no]:y
The configuration is applied, and the switches reload.
To verify switches are in SmartFabric mode, run the following command on each switch:
OS10# show switch-operating-mode Switch-Operating-Mode : Smart Fabric Mode