Home > Networking Solutions > Converged and Hyperconverged Solutions > VxRail Networking Solutions > Guides > Dell EMC Networking SmartFabric Services Deployment with VxRail 4.7 > Configure management settings for new switches
A unique IP address is configured on the OOB management interface of each switch to be added to the SmartFabric. A management route is also configured if routing is used on the OOB management network.
Note: Configure a unique OOB management IP address for each switch. The management route should not be 0.0.0.0/0, or this may interfere with the data network’s default route. Use a specific destination prefix, as shown in the example below.
This is done on every switch to be added to the SmartFabric as follows:
OS10# configure terminal
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 100.67.167.32/24
OS10(conf-if-ma-1/1/1)# no shutdown
OS10(conf-if-ma-1/1/1)# exit
OS10(config)# management route 100.67.0.0/16 100.67.167.254
OS10(config)# end
OS10# write memory
Note: If % Error: ZTD is in progress(configuration is locked) is preventing entry into configuration mode, enter the command ztd cancel to proceed.
Other global settings may also be configured here, such as ip name-server and ntp server if used by the switch. These settings are not required for the deployment example in this guide. The hostname of the switch may be configured at the CLI or in the SFS GUI. In this guide, the SFS GUI is used.