After the Dell EMC Cloud for Microsoft Azure Stack Hub deployment is complete, see the Dell EMC Azure Stack Deployment Workbook.
For all installations, you can directly connect to the Dell EMC MGMT and OpenManage Enterprise virtual machines using any protocol from any network that is routable to the Azure Stack Hub environment.
Also, during the design stage, you must define a list of permitted networks that allow access to the switch management interfaces, HLH operating system, and HLH iDRAC. To verify what networks are added to the ACLs; go to the Scale Unit (SA) tab and go to the Permitted Network Addresses section, as shown in the following figure:
Figure 1. Permitted Networks Addresses
If you have not defined the permitted networks, you can only access the devices through the MGMT virtual machine.
To obtain the IP addresses necessary to manage the Azure Stack Hub, select the IP Assignments tab. See the following table and go to the appropriate section and item to find the device IP that you require.
Device |
Section |
Item |
Switch - BMC |
Rack01-SwitchMgmt |
Gateway |
Switch - ToR 1 |
TOR1 |
|
Switch - ToR 2 |
TOR2 |
|
iDRAC - HLH |
Rack01-BMCMgmt |
HLH-BMC |
iDRAC - SU Nodes |
(Prefix)-S1-N(Node) |
|
HLH |
HLH-OS |
|
MGMTVM |
External1 |
|
OMEnt |
External3 |
For example, to find the Switch - BMC management interface IP, go to the Rack01-SwitchMgmt section, and then look for the Gateway item, as shown in the following figure:
Figure 2. Example of finding management interface IP address
To obtain the credentials that were used during the setup of your system, see the Credentials tab, as shown in the following figure:
Figure 3. Azure Stack credentials
For details on how to rotate these credentials, see Chapter 6: Credential Management.