Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Architecture Guide—VMware Cloud Foundation 4.1 on VxRail 7.0
NSX-T WLD Design
Introduction Application Virtual Network (AVN) NSX-T transport zone design NSX-T segments Uplink profile design Transport node profiles NSX-T Edge node design NSX-T Mgmt WLD physical network requirements NSX-T VI WLD physical network requirements NSX-T deployment in Mgmt WLD NSX-T deployment in VI WLD

NSX-T segments

  • Segments are used to connect VMs to Layer 2 networks, and they can be either VLAN or Overlay segments. For the Mgmt WLD, if AVN is enabled during the deployment, four segments are created. Two segments are created for the AVN networks, Region A and xRegion, to be used for the vRealize Suite of components. Two segments are created to allow Edge node traffic to flow through the ESXi hosts to the physical network. Following is the complete list of segments that are created with AVN enabled to support the virtual infrastructure for an SDDC.

    Table 7.              NSX-T Segments for Mgmt WLD

    Segment

    Transport Zone

    VLAN (example)

    Region A Segment (AVN Network)

    Overlay

    None

    xRegion Segment (AVN Network)

    Overlay

    None

    Edge-uplink01

    VLAN (edge uplink TZ)

    105

    Edge-uplink02

    VLAN (edge uplink TZ)

    106

    For the VI WLD, no segments are created when a VI WLD is deployed and clusters are added. If the edge automation is used to deploy the NSX-T Edges from SDDC manger, the edge uplink segments are created at this time.

next

Uplink profile design