Your Browser is Out of Date

ShareDemos uses technology that works best in other browsers.
For a full experience use one of the browsers below
Architecture Guide—VMware Cloud Foundation 4.1 on VxRail 7.0
NSX-T WLD Design
Introduction Application Virtual Network (AVN) NSX-T transport zone design NSX-T segments Uplink profile design Transport node profiles NSX-T Edge node design NSX-T Mgmt WLD physical network requirements NSX-T VI WLD physical network requirements NSX-T deployment in Mgmt WLD NSX-T deployment in VI WLD

NSX-T Mgmt WLD physical network requirements

  • The following NSX-T external network requirements must be met before deploying the Mgmt WLD:

    • Minimum 1600 MTU for Geneve (Overlay) traffic, 9000 MTU is recommended.
    • Host Overlay VLAN is created on the physical switches.
    • Host Overlay VLAN added to the trunk ports connecting to the VxRail nodes.
    • DHCP is configured for each VLAN to assign the Host TEPs IP.
    • IP Helper on the switches if the DHCP server is in different L3 network.

    If Application Virtual Network (AVN) is enabled, the following additional requirements must be met before deployment:

    • Layer 3 license requirement for peering with T0 Edges.
    • BGP is configured for each router peering with a T0 Edge.
    • Two Uplink VLANs for T0 Edge external connectivity to physical network.
    • Edge Overlay VLAN is created on the physical switches.
    • Uplink and Overlay VLANs added to the trunk ports connecting to VxRail nodes.

next

NSX-T VI WLD physical network requirements