Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
E2E Deployment and Operations Guide with Switchless Networking: Microsoft HCI Solutions from Dell Technologies
About using this guide Deployment Introduction Solution Overview Solution Deployment
Solution Deployment
Solution deployment introduction
Deployment prerequisites
Change operating system to iDRAC pass-through IPs Install Windows Admin Center Install OpenManage Integration with Microsoft Windows Admin Center
Predeployment configuration
Configuring network switches Configuring iDRAC and BIOS Configure Intel E810 or E823 NICs
Cabling instructions
Three-node, single-link full mesh switchless interconnect Two-node, back-to-back connected architecture Three-node, dual-link full mesh switchless interconnect
Operating system deployment
Manual operating system deployment Factory-installed operating system deployment Configure host networking Install roles and features
Change the hostname
Registry settings
Joining cluster nodes to an Active Directory domain
Verifying and updating firmware and software compliance
Configuring firewall settings
Switchless Architecture with Network ATC References GPU Integration Day 1 operations Managing and monitoring clusters with Windows Admin Center Dell OpenManage Integration with Windows Admin Center Updates and maintenance Secure connect gateway References

Registry settings

Home > Integrated Products > Microsoft HCI Solutions from Dell Technologies > Guides 22H2 and earlier > E2E Deployment and Operations Guide with Switchless Networking: Microsoft HCI Solutions from Dell Technologies > Registry settings

Registry settings