Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
E2E Deployment and Operations Guide with Stretched Cluster: Integrated System for Microsoft Azure Stack HCI
About using this guide Introduction Solution overview Solution deployment Creating a stretched cluster
Creating a stretched cluster
Introduction
Test-Cluster
Cluster creation
Configuring host networking
Creating a cluster
Configuring a cluster witness
Creating required intents for a stretched cluster
Volumes
Storage efficiency
Test-SRTopology
Virtual Machines Failure/Recovery from failure of Site/Node Appendices Day 1 operations Managing and monitoring clusters with Windows Admin Center Dell OpenManage Integration with Windows Admin Center Updates and maintenance References

Introduction

Home > Integrated Products > Microsoft HCI Solutions from Dell Technologies > Guides 22H2 and earlier > E2E Deployment and Operations Guide with Stretched Cluster: Integrated System for Microsoft Azure Stack HCI > Introduction

Introduction

  • This section outlines the steps that are needed for configuring a stretched cluster. Complete the network configuration on all nodes for the network topology applicable to you. A sample IP address schema is provided for both supported network topologies in the previous section of this guide. Consider these points before you begin:

    • Ensure management IPs of all nodes are reachable from any host
    • Ensure static routes are configured on all hosts for inter-site communication using the Replica network
    • Ensure all nodes from Site A can reach corresponding Replica IPs on Site B using the Replica path