Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
E2E Deployment and Operations Guide with Scalable Networking: Microsoft HCI Solutions from Dell Technologies
About using this guide Deployment Introduction Solution Overview Solution Deployment Scalable Architecture with Network ATC GPU Integration Day 1 operations Managing and monitoring clusters with Windows Admin Center Dell OpenManage Integration with Windows Admin Center Updates and maintenance
Updates and maintenance
Firmware and driver updates using the manual method
Preparing for maintenance operations Placing an AX node in maintenance mode Obtaining the firmware catalog for AX nodes or Ready Nodes Updating the AX node by using iDRAC out of band Updating the out-of-box drivers Exiting the AX node from maintenance mode
Restarting a cluster node or taking a cluster node offline
Expanding the Azure Stack HCI cluster
Azure Stack HCI node expansion Storage Spaces Direct storage expansion
Extending volumes
Performing AX node recovery
Configuring RAID for operating system drives
Operating system recovery
Manual operating system recovery Factory operating system recovery iDRAC Service Module (iSM) for AX nodes and Storage Spaces Direct Ready Nodes FullPowerCycle
Secure connect gateway References

Firmware and driver updates using the manual method

Home > Integrated Products > Microsoft HCI Solutions from Dell Technologies > Guides 22H2 and earlier > E2E Deployment and Operations Guide with Scalable Networking: Microsoft HCI Solutions from Dell Technologies > Firmware and driver updates using the manual method

Firmware and driver updates using the manual method