Expanding the Azure Stack HCI cluster

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below

E2E Deployment and Operations Guide - Cluster Creation Using Windows Admin Center (WAC)

Preparing for maintenance operations Placing an AX node in maintenance mode Obtaining the firmware catalog for AX nodes or Ready Nodes Updating the AX node by using iDRAC out of band Updating the out-of-box drivers Exiting the AX node from maintenance mode

Azure Stack HCI node expansion Storage Spaces Direct storage expansion

Configuring RAID for operating system drives

Manual operating system recovery Factory operating system recovery iDRAC Service Module (iSM) for AX nodes and Storage Spaces Direct Ready Nodes FullPowerCycle

Secure connect gateway References

United States/English

Thank you for your feedback!

Expanding cluster compute or storage capacity are tasks performed during cluster operations. This section provides instructions for performing these tasks.

Figure 19. Expanding the Azure Stack HCI cluster
- Azure Stack HCI node expansion
- Storage Spaces Direct storage expansion