Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Dell Networking SmartFabric Services Deployment with VxRail 7.0.400
Introduction Hardware used in this guide Topology Deployment Planning Configure the First Leaf Switch Pair Deploy First VxRail Cluster Expand to Multirack Add a second VxRail cluster Deploy and Configure OMNI Validated Components CLI Commands
CLI Commands
Switch CLI validation commands
Return to Full Switch mode
Cisco Nexus External Switch Configuration Example Support and Feedback

Return to Full Switch mode

Home > Integrated Products > VxRail > Guides > Dell Networking SmartFabric Services Deployment with VxRail 7.0.400 > Return to Full Switch mode

Return to Full Switch mode

  • CAUTION: The following command deletes the existing switch configuration.

    To delete the existing switch configuration and go from SmartFabric mode back to Full Switch mode, run the following commands on each switch: 

    Leaf1A# configure terminal
    Leaf1A(config)# no smartfabric l3fabric
    Reboot to change the personality? [yes/no]:y

    The switch reboots into Full Switch mode. The mode can be verified with the following command: 

    OS10# show switch-operating-mode
    Switch-Operating-Mode : Full Switch Mode